2Pcs Premium Upstream O2 Oxygen Sensor For 1993-1990 Nissan 300Zx V6 3.0L
- Item condition:
- New
- Ended:
- Jan 13, 08:01 PST
- Price:
- $40.45 View item
- Shipping:
- FREE
- Item location:
- Ontario,CA,USA
- Ships to:
- Worldwide
Item specifics
-
- Brand:
- Generic
-
- Manufacturer Part Number:
- B2OS209
-
- Warranty:
- 1 Year
-
- Fitment Type:
- Direct Replacement
-
- Position:
- 2 Upstream
-
- Wire Quantity:
- 3
-
- Sensor Type:
- Heated
-
- Connector Gender:
- 2 Male
-
- Wire Harness Length:
- 20.87
-
- Thread Diameter:
- 0.708
-
- UPC:
- 680587541884
- Home
- Feedback
- Follow
- About Us
- Contact Us
Store Categories
- WATER PUMP
- FUEL PUMP
- HUB BEARING ASSEMBLY
- OXYGEN SENSOR
- SHOCK ABSORBER
- CARBURETOR
- Cell Phone Parts
- FAN CLUTCH
- VACUUM PUMP
- WRENCH & TOOL
- TIRE PRESSURE GAUGE
- Power Steering Pump
- Other
Details
2Pcs Premium Upstream O2 Oxygen Sensor For 1993-1990 Nissan 300Zx V6 3.0LMake Model Engine Year Notes NISSAN 300ZX V6-3.0 1993-1990 2Pcs Upstream Q&A
Q: Why does the oxygen sensor have false alarm, after installation ?
A: The clearing of the errors can be obtained on most systems when the vehicle battery is disconnected for at least 60 seconds. The assignment of the new sensor parameters is done automatically when the errors are cleared, but in some systems a short adapting tour is required. In this case the vehicle has to be driven on the road for some 10-15 minutes, in order to have the ECU adapt itself to the new sensor.
Q: How do I know the O2 sensor is good or not ?
A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.
Q：How should I install oxygen sensor ?
A: The following is the installation instructions: Use the correct part number as listed in the application catalogue ,Do not use sensor if i has been dropped ,Remove protection cap just prior to installation;
Firstly install sensor body ensuring lead wire is not twisted or bent , Do not use impact wrench or socket type wrench to install sensor ,M18 sensors - install finger tight...
