2Pcs Wideband Upstream Oxygen Sensor For Jaguar S-type Super V8 XFR XJ8 XK XK8
- Item condition:
- New
- Ended:
- Feb 5, 01:26 PST
- Price:
- $74.97 View item
- Shipping:
- FREE
- Item location:
- Ontario,CA,USA
- Ships to:
- Worldwide
Item specifics
-
- Brand:
- Generic
-
- Manufacturer Part Number:
- B2OS526
-
- Interchange Part Number:
- 15375 75-3907 25698
-
- Other Part Number:
- 15375 75-3907 25698
-
- Warranty:
- 1 Year
-
- Fitment Type:
- Direct Replacement
-
- Position:
- 2 Upstream
-
- Wire Quantity:
- 4 & 4
-
- Sensor Type:
- Heated & Heated
-
- Wire Harness Length:
- 11.89 & 11.89
-
- UPC:
- 680587601977
- Home
- New Arrivals
- Ending Soon
- Feedback
- Contact Us
Store Categories
- Water Pump
- Fuel Pump
- Hub Bearing Assembly
- CV AXLE
- Other
2Pcs Wideband Upstream Oxygen Sensor For Jaguar S-type Super V8 XFR XJ8 XK XK8
PRODUCT FEATURES
- 100% High quality brand new.
- 100% factory tested to meet or exceed all original equipment specifications.
- Quality components for proper fit and long-life performance.
- Each sensor has application specific design to ensure a perfect fit for easy installation.
Q: Why does the oxygen sensor have false alarm, after installation ?
A: The clearing of the errors can be obtained on most systems when the vehicle battery is disconnected for at least 60 seconds. The assignment of the new sensor parameters is done automatically when the errors are cleared, but in some systems a short adapting tour is required. In this case the vehicle has to be driven on the road for some 10-15 minutes, in order to have the ECU adapt itself to the new sensor.
Q：How should I install oxygen sensor ?
A: The following is the installation instructions: Use the correct part number as listed in the application catalogue ,Do not use sensor if i has been dropped ,Remove protection cap just prior to installation;
Firstly install sensor body ensuring lead wire is not twisted or bent , Do not use impact wrench or socket type wrench to install sensor ,M18 sensors - install finger tight then 1/2-3/4 turn with a wrench (35-45Nm) ;
Then connect and route lead wire as originally installed , Do not allow lead wire to touch exhaust manifold or any other hot component ,Do not apply any...
