1997-2002 Rear Trail Arm + Skid Plate Center Frame Rust Repair Jeep Wrangler TJ
- Item condition:
- New
- Ended:
- Aug 31, 10:19 PDT
- Price:
- $325.00 View item
- Shipping:
- FREE
- Item location:
- Cresco,PA,USA
- Ships to:
- Worldwide
Item specifics
-
- Placement on Vehicle:
- Right and Left Rear and Center
-
- Country/Region of Manufacture:
- United States
-
- Surface Finish:
- Raw steel
-
- Manufacturer Part Number:
- CMBO4PCREAR
-
- Brand:
- Pocono Metal Craft
-
- Warranty:
- 1 Year
-
- UPC:
- 644725129747
American Made from High Strength 10 Gauge Rolled Steel
Shipped within 24 hoursRear Trail Arm and Skid Rust Repair Kit 97-02
Rear and middle driver and passenger side repair pieces for Jeep Wrangler years 1997-2002. This set includes the rear trail arm repair pieces and the center skid plate repair pieces.
Trail Arm
The trail arm pieces will fix the areas in front of the rear axles where rot typically occurs.
On your original frame there is a factory drilled access hole, which allows debris and water to enter and creat rust over time.
Our design includes a drain hole to prevent this from happening again.
Piece includes the lower control arm and body mounts.
New control arm bolts included.
Each piece measures approximately 22" end to end.
Skid Plate
The skid plate pieces are full length repair pieces that completely repair the areas in front of and behind the skid plates.
These pieces gets attached to the frame and the transfer case and transmission gets bolted to them. Hardware is included.
Each piece measures approximately 43 1/2" end to end.
Constructed of 10 gauge rolled high carbon steel which is thicker than your existing frame and thicker than the other sellers.
Always In stock! Pieces are designed to attach directly to each other with no spacing in betweenWhy buy from us?
- We use the best material. Made from 10 gauge rolled hi carbon steel our parts are thicker and stronger than OEM and all other sellers.
- We have the best fabricators. Our welding technicians are required to obtain a 3G certification in mig welding AND have significant experience before performing any welds on any parts we sell...
