2002-2008 MAZDA MPV 6 2M2E-A7B FLOW MATCHED FUEL INJECTOR SET
- Item condition:
- Remanufactured
- Ended:
- Dec 16, 17:15 PST
- Price:
- $38.00 View item
- Shipping:
- FREE
- Item location:
- Denver,CO,USA
- Ships to:
- Worldwide
Item specifics
-
- OE Spec or Performance/Custom:
- OE Spec
-
- Surface Finish:
- composite plastic
-
- Modified Item:
- No
-
- Country/Region of Manufacture:
- United States
-
- Interchange Part Number:
- MP4206 842-12319 161111 M875 67427 FJ826
-
- Number of Pieces:
- 6
-
- Type:
- Multi-Port
-
- Manufacturer Part Number:
- 2M2E-A7B
-
- Other Part Number:
- 4181/195500-4181 AJ5513250 2M2E-A7B/2M2E9F593A7B
-
- Brand:
- Denso
-
- Fitment Type:
- Direct Replacement
-
- Warranty:
- Lifetime
-
- UPC:
- Does not apply
These are GENUINE OEM DENSO injectors. The same ones that came on your vehicle when it was new. You will see lots of eBay seller selling 'new' injectors. But if you check the brand name of the injectors themselves, they are some other brand entirely. Like MOSTPLUS or SUPERV, or WAYCOMO. These are cheap Chinese knockoff injectors, and the sellers who sell them are all new sellers. That is because they fail quickly and when you go to get warranty, they are nowhere to be found. So stick with OEM, the folks who made your car sure did.
These injectors are the correct OEM DENSO injectors part number 2M2E-A7B and they fit the following vehicles with the 3.0L V6 engine:
Mazda 6 03-08 Mazda MPV 02-06
All injectors are covered with a Lifetime Warranty. This lasts as long as you own the vehicle.
All injectors are serviced as stated below, proprietary service steps have been left out:
* Disassembled and externally cleaned in boiling solution bath
* Checked for major cosmetic damage
* Internally cleaned using ultrasonic baths using our proprietary cleaning solutions.
* Back-flushed to remove any internal debris (multi-step process)
* Injector flow and spray pattern is tested using out ASNU calibration bench
* A high pressure leak test is performed
* OHM Tested for electrical shorts
* Injectors are run up to 9k RPM on a 30 second test to see if they will fail
* Flow matched using our ASNU calibration bench
* Re-assembled with new filters and VITON orings and seals
For warranty issues or any kind of problem please contact our customer service 4 O 2 6 one 6 niner 5 niner 3 or via eBay.
