1320 Performance FJ cruiser 4 runner GX460 GX470 BMC body mount chop kit
- Item condition:
- New
- Ended:
- Feb 1, 21:35 PST
- Price:
- $16.99 View item
- Shipping:
- $6.42
- Item location:
- Elk Grove,CA,USA
- Ships to:
- Worldwide
Item specifics
-
- Manufacturer Part Number:
- 1320-FJ-4rn-gx-BMC
-
- Brand:
- 1320 performance
-
- Fitment Type:
- Performance/Custom
-
- UPC:
- Does not apply
1320 Performance FJ Cruiser 4 runner GX460 GX470 Body Mount chop kit give you more room in the wheel well for larger tires in the front of your vehicle by remove part of the front body mounts so the tires wont rub against it.
Left and Right water jet cut and Hydraulic bend BMC plates. The plates will require to be welded in. Thick steel plate for easy welding and follow the curve to cut. Installation instructions included below so its easy to have a local welding shop install these.
Our BMC Kit fits 2007-2014 Toyota FJ Cruiser, 03-09 GX470, 10-13 GX460, 03-13 4Runner
Basic Instruction: if you never work with grinder, hack saw or welder please seek professional help.
1 Open hood, Remove The negative ground cable from the battery. 2 Jack up the vehicle and Remove both the front wheels 3 Remove any installed side steps or rock sliders from the truck to gain more space to work4 Remove the factory plastic mud guard the body mounts. 5 Clean off the whole body mount with soap and water on both sides and dry. 6 Lay the body mount chop pieces out. The side with the radius is the top. 7 Hold the correct body mount chop plate up and visualize how it will go on before you make any cuts. You want to make the most room toward the wheel well where the tire rotates into. 8 Use the opposite side body mount chop plate upside down (Upside down it has the same bend location as the other side and has the 90* corners as a guide) Maneuver it so it’s balanced between the front and back of the stock mount. You want to clear the most room toward the wheel well. 9 Use a light colored paint pen to mark the cut. Make lines up the front and back of the body mount in line with your lower marks. 10 Cut the stock body mount end off, using your guide marks. 11 Do the other side. 12 Remove the lower body mount nut, washer and large rubber body mount prevent and fire hazard. 13 Weld the correct body mount chop cap on doing stitch welds...
