Mag Hytec Rear Differential Cover fits 04-14 Nissan Titan Pickup Truck MT-#44
- Item condition:
- New
- Ended:
- Jan 27, 13:27 PST
- Price:
- $247.00 View item
- Shipping:
- FREE
- Item location:
- Phoenix,AZ,USA
- Ships to:
- Worldwide
Item specifics
-
- Manufacturer Part Number:
- MT-44
-
- Interchange Part Number:
- #MT-44 MT44
-
- Warranty:
- Yes
-
- Part Brand:
- Mag-Hytec
-
- Placement on Vehicle:
- Rear
-
- Fitment Type:
- Direct Replacement
-
- Modified Item:
- No
-
- Non-Domestic Product:
- No
-
- Mounting Hardware Included:
- Yes
-
- Country/Region of Manufacture:
- United States
This is a brand new Mag-Hytec Differential Cover with full factory warranty. We are an Authorized Dealer of Mag-Hytec and carry the full line of products.
Fits the following applications:
'04-'14 Nissan Titan Pickup
Overall height 3 1/2"
Lube Locker Custom Reusable Gasket
Includes: Bolt kit, Drain Plug and Dip Stick and Lube Locker Custom Reusable Gasket.
Capacity: 4 Quarts
Part # : MT-#44
Heavy Duty differential covers and transmission pans provide increased lubricant and cooling capacity for hard working recreational and service vehicles. Mag-Hytec covers and pans set your vehicle apart in both aesthetics and function - cast in A356-T6 aluminum and texture powder coated black with machined cooling fins. Magnetic drain plugs trap worn gear material promoting fluid integrity. Each unit is fitted with ARP 568 O-rings for superior sealing. All hardware is 303 stainless steel, in most applications no gasket or sealant is required, and all Mag-Hytec parts are covered by a lifetime limited warranty. Depend on Mag-Hytec when you're pulling a heavy load.Avoid costly reapirs - Extend the life of your Vehicle - Expand oil Capacity - Runs Cooler, Lasts Longer
Average of double the fluid capacity Ease of Service The dipstick is knurled for quick removal, the flat is marked low/high to check lube level and a magnet, which acts as an open filter is in the lower end. The MS 7/8 - 14 THD port is large enough to use for filling. The magnet-filled drain plug is the same MS port as the dipstick. Both the dipstick and drain are O-ring sealed. The sending unit fitting is 1/8 pipe THD and shipped with a stainless pipe plug. The calibration plug is centered on the serial number plate and approximates the stock cover fill plug for factory fluid level. The O-ring is snapped into the inverted "V" groove for a positive seal without gasket or...