Ford Highboy Rear Leaf Spring brackets for Super Duty springs 1973-77 F250 4wd
- Item condition:
- New
- Ended:
- Oct 20, 21:55 PDT
- Price:
- $335.00 View item
- Shipping:
- FREE
- Item location:
- Battle Ground,WA,USA
- Ships to:
- Worldwide
Item specifics
-
- Country/Region of Manufacture:
- United States
-
- Manufacturer Part Number:
- NA
-
- Brand:
- NA
-
- Warranty:
- 60 Day
These spring brackets are designed to mount onto Ford F250 4wd highboy trucks and allow you to install 1999-2007 Super Duty leaf springs. This works particularly well with Pro Comp lift springs. Part number 22415 is pictured with the green truck. Your factory highboy has a 4" lift block. Pro Comp 22415 used with these brackets and used without any lift block will lower your truck 1". So in other words, use a 1" block to maintain factory height, 2" block to raise 1", etc.
Here is the neat thing about these spring brackets: Every bracket uses at least one factory drilled frame hole! You don't even need a tape measure to mount these in. No worries or headache aligning it all. You do need to drill a grand total of ten 1/2" holes in your frame (out of a total of 16 bolt holes to mount these). The brackets work as a template for the drilling location- no guess work.
This can be used with your original Dana 60, etc. you do need to cut your factory perches and weld new perches meant for a 3" wide spring.
Also, Pro Comp 23311 gives 3" additional compared to 22415. This means that 23311 used without any lift block gives about a 2" lift over factory highboy height.
This auction includes all four brackets, enough to swap out both of your rear springs for super duty springs. 16 new 1/2" grade 8 bolts and lock nuts are included!
You will need to separately purchase these things:
Rear 1999-2007 Super Duty leaf springsAxle leaf spring perches for 3" Spring. Factory Dana 60 axle tube is 3.125" Diameter. (See Ballistic Fabrication 1069-25)
Leaf Spring plate (See Ballistic Fabrication BRK-1070-22) Leaf Spring Shackles (722-018 for example)
U Bolts- upgrade to 5/8"! (Superlift 11244 lets you run a 4" + lift block, Superlift 11184 is pictured and lets you run a small 1 or 2" block)
1/2" Drill bits- I recommend using a 1/4" drill bit first to cut a pilot hole, then finishing with 1/2"
