Ford E150 F150 4.6 V8 04-09 FUEL INJECTOR SET LIFETIME WARRANTY
- Item condition:
- Remanufactured
- Ended:
- Jan 6, 15:06 PST
- Price:
- $70.00 View item
- Shipping:
- FREE
- Item location:
- Denver,CO,USA
- Ships to:
- Worldwide
Item specifics
-
- OE Spec or Performance/Custom:
- OE Spec
-
- Surface Finish:
- composite plastic
-
- Country/Region of Manufacture:
- United States
-
- Number of Pieces:
- 8
-
- Manufacturer Part Number:
- 4L3E-B4C
-
- Brand:
- Bosch
-
- Fitment Type:
- Direct Replacement
-
- Warranty:
- Lifetime
-
- UPC:
- Does not apply
These are GENUINE OEM BOSCH injectors. These injectors were used on the 4.6 engines in Lincolns. The trucks have a lower emissions standard and can get by with a cheaper injector with a different spray pattern. These injectors are spec for the 4.6 Ford engine.
You will see lots of eBay seller selling 'new' injectors. But if you check the brand name of the injectors themselves, they are some other brand entirely. Like MOSTPLUS or SUPERV, or WAYCOMO. These are cheap Chinese knockoff injectors, and they are best to be avoided. They won’t tune properly and they fail early and often. We only sell injectors by the 5 major manufacturers. Delphi, Bosch, NIKKI, Siemens, and Denso.
These injectors fit the following Ford vehicles with the 4.6L V8 engine
2004-2008 Ford F150 4.6L 2004-2005 Mercury Mountaineer 4.6L 2004-2005 Ford Explorer 4.6L 2004-2009 Ford E150 4.6L 2003-2009 Ford E250 4.6L 2004-2005 Ford E150 Club Wagon 4.6L These injectors are a plug-and-play upgrade for your stock 4L3E-B4C fuel injectors
We have been told that the injector retainer clip slot is in a different spot on some of the other Ford injectors. This is not an issue. The clips are there to allow the injectors to be installed all at once at the engine factory. Once the fuel rail is bolted down tot he engine, they are secured. Many engines do not even use the clips.
All injectors are covered with a Lifetime Warranty. This lasts as long as you own the vehicle.
All injectors are serviced as stated below, proprietary service steps have been left out:
* Disassembled and externally cleaned in boiling solution bath
* Checked for major cosmetic damage
* Internally cleaned using ultrasonic baths using our proprietary cleaning solutions.
* Back-flushed to remove any internal debris (multi-step process)
* Injector flow and spray pattern is tested using out ASNU calibration...
