Mag Hytec Rear Differential Cover 89-02 Dodge Ram Pickup Truck w/ Dana # 70 Axle
- Item condition:
- New
- Ended:
- Dec 11, 17:53 PST
- Price:
- $256.50 View item
- Shipping:
- FREE
- Item location:
- Phoenix,AZ,USA
- Ships to:
- Worldwide
Item specifics
-
- Manufacturer Part Number:
- Dana# 70
-
- Warranty:
- Yes
-
- Part Brand:
- Mag-Hytec
-
- Placement on Vehicle:
- Rear
-
- Fitment Type:
- Direct Replacement
-
- Modified Item:
- No
-
- Custom Bundle:
- No
-
- Mounting Hardware Included:
- Yes
-
- Country/Region of Manufacture:
- United States
This is a brand new Mag-Hytec Differential Cover with full factory warranty. We are an Authorized Dealer of Mag-Hytec and carry the full line of products.
Fits the following applications:
'89-'93 Dodge Ram - All 2500/3500 trucks
'94-'02 Dodge Ram 2500 - Automatic Only
Overall height 4 1/8"
Includes: Bolt kit, Drain Plug and Dip Stick.
Capacity: 6 Quarts
Part #: Dana #70
Heavy Duty differential covers and transmission pans provide increased lubricant and cooling capacity for hard working recreational and service vehicles. Mag-Hytec covers and pans set your vehicle apart in both aesthetics and function - cast in A356-T6 aluminum and texture powder coated black with machined cooling fins. Magnetic drain plugs trap worn gear material promoting fluid integrity. Each unit is fitted with ARP 568 O-rings for superior sealing. All hardware is 303 stainless steel, in most applications no gasket or sealant is required, and all Mag-Hytec parts are covered by a lifetime limited warranty. Depend on Mag-Hytec when you're pulling a heavy load.Avoid costly reapirs - Extend the life of your Vehicle - Expand oil Capacity - Runs Cooler, Lasts Longer
Average of double the fluid capacity Ease of Service The dipstick is knurled for quick removal, the flat is marked low/high to check lube level and a magnet, which acts as an open filter is in the lower end. The MS 7/8 - 14 THD port is large enough to use for filling. The magnet-filled drain plug is the same MS port as the dipstick. Both the dipstick and drain are O-ring sealed. The sending unit fitting is 1/8 pipe THD and shipped with a stainless pipe plug. The calibration plug is centered on the serial number plate and approximates the stock cover fill plug for factory fluid level. The O-ring is snapped into the inverted "V" groove for a positive seal without gasket or silicone. Plugs,...