2pc 2 Inch Wheel Adapters Hubcentric w/ Lip | 5x5.5 to 8x170 | 14x1.5 Studs
- Item condition:
- New
- Ended:
- Feb 9, 17:55 PST
- Price:
- $200.59 View item
- Shipping:
- FREE
- Item location:
- Fremont,CA,USA
- Ships to:
- Worldwide
Item specifics
-
- Brand:
- Customadeonly
-
- Manufacturer Part Number:
- WWW294-50B
-
- Surface Finish:
- Anodized Silver
-
- Bolt Pattern:
- Allowing 8X170 Wheels to Fit On 5X5.5 (5X139.7) Hub
-
- Hub Bore Size:
- 108mm to 125mm
-
- Material:
- High Grade T6 Aluminum w/ Class 10.9 Carbon steel wheel studs
-
- Spacer Type:
- Lug Centric Wheel Adapters
-
- Thickness:
- 50mm = 2" Inch
-
- Thread Type:
- 14x1.5 14mm x 1.5 Grade 10.9
-
- Vehicle Bolt Pattern::
- 5x5.5" (5x139.7)
-
- Wheel Bolt Pattern::
- 8x170
- Spacer Width: 50mm (2 Inch) Each Side
- Quantity: 2 Pieces
- Bolt Pattern: 5X5.5 (5X139.7) TO 8X170 (Allowing you to run 8X170 Wheels to Fit On 5X5.5 (5X139.7) Hub)
- Center Bore: 108 to 125mm (You can use hub ring to maintain the adapter in the centric state. For example, if your hub size is 78.1mm, you can use a set of 78.1 to 108 hub ring)
- Thread Pitch: 14X1.5
- Spacer Type: Conversion Adapters
- This Adapter set includes open end lug nuts (14x1.5) to secure the spacers onto your factory hubs. If your car equipped with a different thread pitch, you will need to purchase a set of open end, acorn lug nuts w/ matching thread pitch type to complete the installation
- Installation Note: This is a 2-Piece Adapter where the bottom plate will be mounted onto the hub. The factory studs may need to be trimmed down in order for the top plate to mount onto the bottom adapter plate without any slight gap in between.(VERY IMPORTANT!! ) Make sure hub, studs or lug nuts from the vehicle do not contact the 2nd piece of the adapter or it will cause failure
- Test fit the product before fully bolt down - Securely tightened the black bolt that uses to hold the 2 piece adapters together (Torque set at 55-60lb max)
- Be sure to retorque the adapters after 20-25 miles of driving
- **The height of the base plate adapter is approx. 30mm & the height of the factory studs can not exceed 28mm to allow the top plate adapter to go on properly, Please be sure to check your vehicle prior to purchase
