90mm Enlarged Throttle Body for 2003-2012 Dodge Ram Jeep Hemi 5.7L 6.1L 6.4L
- Item condition:
- New
- Ended:
- Oct 25, 20:26 PDT
- Price:
- $269.00 View item
- Shipping:
- FREE
- Item location:
- Las Vegas,NV,USA
- Ships to:
- Worldwide
Item specifics
-
- Superseded Part Number:
- 1782
-
- Modified Item:
- No
-
- Interchange Part Number:
- 1782
-
- Material:
- Aluminum
-
- Surface Finish:
- New Aftermarket Replacement
-
- Note:
- No Tune Required; Relearn Process is needed.
-
- Engine & Transmission::
- 5.7L V8 - Gas, 6.4L V8 - Gas,6.1L V8 - Gas
-
- Manufacturer Part Number:
- BBK 1782
-
- Other Part Number:
- BBK-1782
-
- Brand:
- Auto Parts Factory Direct
-
- Fitment Type:
- Performance/Custom
-
- Warranty:
- 6 Month
-
- UPC:
- 7445948619526
Enlarged 90mm Throttle Body Assembly for 2003-2012 Dodge Hemi 5.7/6.1L/6.4L
Enlarged Intake Flap (90mm), Original TBI bore size 80 mm ;
No Tune Required; Relearn Process is needed.
Improved Throttle Response And Acceleration ;
Increased Air-Flow Over Stock Unit For Add Horsepower (12+) And Torque.
Application:
All 2003-2012 5.7L, 6.1L and 6.4L applications. (Will not fit any 2013/2014 applications at this time)
California Residents
To confirm your vehicle's CARB certification, please enter EO number at www.arb.ca.gov
***Installation Instructions :
1. Disconnect the negative battery terminal.
2. Disconnect the air temperature sensor plug and the throttle body control motor plug.
3. Loosen the clamps on the air intake tube and air box, and then remove the tube.
4. Remove the four bolts that secure the throttle body to the intake manifold.
5. Remove the stock throttle body. The stock O-ring seal will be re-used. Be sure to wipe off and debris from the gasket.
6. Bolt on this Enlarged Throttle Body using the stock hardware. On the 5.7L Hemi Plastic manifolds, take extra care when re-installing the mounting bolts. (The “Speed Nut” type threaded nuts can be easily stripped. Make sure the threads of the bolts are properly engaged with the nut before tightening. )
7. Re-install the air inlet tube to the Throttle Body and air box and then tighten the clamps.
8. Re-connect the air temperature sensor and the throttle body control motor plug. Re-connect the negative battery terminal and refer to the instruction sheet for throttle relearn procedure.
Legal: Some or all of these parts may not comply with Federal, State, Province, and/or...
