2pcs 02 Oxygen Sensor Up+Downstream For 2009-2012 Chevrolet Malibu L4 2.4L
- Item condition:
- New
- Ended:
- Oct 12, 05:03 PDT
- Price:
- $26.92 View item
- Shipping:
- FREE
- Item location:
- Richardson,TX,USA
- Ships to:
- Worldwide
Item specifics
-
- Item name:
- Oxygen Sensor
-
- Brand:
- Reach
-
- Type:
- Oxygen Sensor
-
- Warranty:
- 2 Year
-
- Fitment Type:
- Direct Replacement
-
- Manufacturer Part Number:
- RC060352G10F
-
- Fits Vehicle:
- Pls See the Compatiblity
-
- Placement on Vehicle:
- Front & Rear
-
- Location:
- Upstream&Downstream
-
- UPC:
- Does not apply
2pcs 02 Oxygen Sensor Up+Downstream For 2009-2012 Chevrolet Malibu L4 2.4L
Product Description
Specification:
* 4 wire configuration
* Interchange Part Number:
* Package Include :2Pcs x Oxygen Sensor (1pcs Upstream & 1pcs Downstream).
* Warranty: 2 Year
Fit Vehicles:
”Please check the part number and item pics clearly, confirm suited to your needs.”
Must know before buying:
The following information is for instructional and guidance reference only.
We try and make them as accurate as we can.If Check Engine Light is on or an OBDII Trouble/Fault code occurs after installation, check the sensor with a voltmeter as below. If the sensor is good, further diagnosis is required. There're many different codes for specific functional failures, which are NOT necessarily relevant to the sensor. Find out what the Code means before leaving any feedbacks.
1. ONLY a defective sensor after tested by a voltmeter is applied to manufacturer warranty.
2. 20% restocking fee is required if buyer bought wrong items due to not paying attention to fitment information and ask for return.
The Price, Quality & Functionality of the O2 Sensor is fully covered under our warranty & return policy. However, refund for any labor cost, expense in a dealer shop or damage due to wrong installation is NOT covered.
Q: How do I know the O2 sensor is good or not?
A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.
Use a 10-mega ohm digital voltmeter. Hook up the voltmeter's red probe to the sensor's signal wire and the black probe to engine ground. (Use back probe method, DO NOT pierce the wire.) For a...
